Datasheet

PEP and Debug Header Specification
DS50001292W-page 88  2006-2015 Microchip Technology Inc.
B.3 8-PIN SIL CONNECTOR
Debug headers with 8-pin Single In-Line (SIL) connectors are compatible with the tools
listed below.
PICkit 3 Programmer/Debug Express
The 6-pin socket of the PICkit 3 may be connected to the 8 header pins by removing
the two DAT and CLK pins. However, this may compromise future use of these
pins/functions with other tools.
FIGURE B-2: 8-PIN SIL CONNECTION TO A PICKIT
MPLAB ICD 3 In-Circuit Debugger
The 6-pin modular cable attached to the MPLAB ICD 3 may be connected to the 8
header pins through the Modular-to-SIL Adapter.
MPLAB REAL ICE In-Circuit Emulator
The 6-pin modular cable attached to the Standard Driver Board may be connected to
the 8 header pins through the Modular-to-SIL Adapter. No SPI trace is available with
this connection because of the loss of the DAT and CLK pins.
The 8-pin socket of the High Speed Driver Board or optional Isolation Unit may be con-
nected directly to the 8 header pins. Be sure to line up pin 1 on the board with pin 1 on
the header.
FIGURE B-3: 8-PIN SIL CONNECTION TO AN EMULATOR
PICkit 3
P
I
C
k
i
t
TOP
1
Header
Connector
TOP
1
DAT
CLK
R
e
m
o
v
e
MPLAB REAL ICE in-circuit emulator
High-Speed Receiver Board or
TOP
Header
Connector
optional Isolation Unit
TOP
11
J1
DAT
CLK
J3
J2