Datasheet

PEP and Debug Header Specification
DS50001292W-page 74  2006-2015 Microchip Technology Inc.
Header Dimensions
The figure below lists the dimensions for the debug header. Dimensions are design
values in inches.
If the length and/or width of the debug header is too large a footprint for the target
board, consider using stand-offs, transition sockets or other extenders in the header
connection socket to raise the header above the target.
FIGURE 3-15: DIMENSIONS - AC244046, AC244047
Dimensions are in inches
Side
Top
0.165 Typical 0.165 Typical
0.062 Typical
0.410 Typical
Target Pin 1 is located
on bottom side of header.
1.930
0.620
1.640
0.320
0.570
ICE Device
6-pin SIL Connector
(0.100 pin spacing)
See Appendix B. “Debug Header
Connections” for details.