Datasheet

PEP and Debug Header Specification
DS50001292W-page 70  2006-2015 Microchip Technology Inc.
Header Dimensions
The figure below lists the dimensions for the debug header. Dimensions are design
values in inches.
If the length and/or width of the debug header is too large a footprint for the target
board, consider using stand-offs, transition sockets or other extenders in the header
connection socket to raise the header above the target.
FIGURE 3-13: DIMENSIONS - AC244035, AC244036
Dimensions are in inches
Side
Top
0.380 Typical
0.165 Typical
0.062 Typical
0.335 Typical
0.710
0.650
0.800
0.345
0.840
0.710
2.575
0.445
0.145
2.190
28-Pin DIP Target Pin 1 is located
on bottom side of header.
44-Pin TQFP Target Pin 1 is located
on bottom side of header.
44-Pin QFN Target Pin 1 is located
on bottom side of header.
40-Pin DIP Target Pin 1 is located
on bottom side of header.
-ICE Device
6-pin SIL Connector
(0.100 pin spacing)
See Appendix B. “Debug Header
Connections” for details.
QFN
TQFP