Datasheet

Optional Debug Headers
 2006-2015 Microchip Technology Inc. DS50001292W-page 59
After the debug header is set up, perform the following steps:
1. Connect the header to the PICDEM MC/MC LV target board.
2. Power the target board. You should see the red LED on the debug header turn
on.
3. Connect the debug tool to the debug header.
4. Program the part with the demo code.
5. Run the program.
6. Press and release switch S2 on the target board to toggle the direction of the
motor’s rotation.
7. Press and release switch S1 on the target board to toggle between running and
stopping the motor.
8. If the motor stops while reversing from a high speed, there could be an
overcurrent condition detected by the system. Reset the system to run the
program again.
Header Limitations
Sometimes a header device (-ICE/-ICD) has operational issues or errata. To determine
if a device on a header has limitations, see your hardware tool documentation.