Datasheet

PEP and Debug Header Specification
DS50001292W-page 58  2006-2015 Microchip Technology Inc.
AC162078
Header Identification
The AC number is used for ordering the Processor Extension Pak, which contains the
debug header. However, this number is not on the header, as the board may be used
for multiple headers by inserting different -ICE/-ICD devices. To identify this header,
use the following information.
Header Setup and Operation
This debug header can be used with the following targets:
• Customer Target Board for PIC18F1230/1330 devices
The target board should have an 18-pin DIP socket to connect to the 18-pin DIP
socket on the debug header.
• PICDEM MC motor control demo board
Use the 28-pin DIP socket on both boards to mount the debug header onto the
PICDEM MC board.
• PICDEM MC LV motor control demo board
Use the 28-pin DIP socket on both boards to mount the debug header onto the
PICDEM MC LV board.
The following sections detail the configuration of the jumpers on the debug header for
use with the above mentioned boards.
CUSTOMER TARGET BOARD
The default configuration is to remove all jumpers.
S1 is not populated and should not be used.
After the debug header is set up, do the following:
1. Connect the header to the target board.
2. Power the target board. You should see the red LED on the debug header turn
on.
3. Connect the debug tool to the debug header.
4. Use MPLAB X IDE and the debug tool to develop your application.
PICDEM MC/MC LV MOTOR CONTROL DEMO BOARDS
To run a BLDC motor on the PICDEM MC board or PICDEM MC LV board using the
supplied firmware, use the following jumper setup:
S1 is not populated and should not be used.
AC Number -ICE/-ICD Device Board Assembly Number
AC162078 PIC18F1330-ICD 02-01896
Jumper Jumper Setting Jumper Jumper Setting
J1 2-3
JP1 Open
J2 2-3
J3 2-3
JP2 Open
J5 2-3
J6 1-2
JP3 Open
J7 1-2