Datasheet

Transition Socket Specification
DS51194S-page 30  2010 Microchip Technology Inc.
SSOP TRANSITION SOCKET
An SSOP transition socket and associated hardware is
shown in Figure 3.
FIGURE 3: SSOP TRANSITION SOCKET
The SSOP transition sockets are similar to the SOIC
transition sockets. There are two parts to the SSOP
transition socket:
1. Adapter socket that connects to the PDIP device
adapter.
2. SSOP header that gets soldered down to the
target application.
The following SSOP transition sockets have been dis-
continued:
• XLT14SS: One adapter socket and three 14-lead
SSOP headers
• XLT20SS: One adapter socket and three 20-lead
SSOP headers
• XLT20SS1: One adapter socket and three 20-lead
SSOP headers
• XLT28SS: One adapter socket and three 28-lead
SSOP headers
• XLT28SS2: One adapter socket and three 28-lead
SSOP headers for PIC16C55/57
See the drawings in this section for layout dimensions
and clearances for tall components.
XLT14SS (Discontinued – see XLT14SS-1)
14-lead DIP to 0.8 mm Adapter Socket
14-lead SSOP Header
Note: To keep the leads straight during assembly
and shipping, the SSOP headers are
shipped with break-away tabs attached to
the leads. Please remove the break-away
tabs before applying power to the target
system. Be careful not to bend the leads
prior to soldering to the target application.
Cable to Processor Module
PDIP Device Adapter
Adapter Socket
SSOP Header
Target/Application Board
SSOP Transition Socket
Gold Standoffs/
Adapters
TOP
VIEW
SIDE
VIEW
REAR
VIEW
FRONT/
BOTTOM
VIEW
A
B
C
D
E
F
G
Shipped with
break-away tabs
attached to leads
Remove prior to
providing power
* Top drawing shown
with clip-on shrouds
installed
UNLESS OTHERWISE SPECIFIED, DIMENSIONS ARE IN
INCHES.
Break-away tabs are to be removed prior to providing power.
TOP
VIEW
SIDE
VIEW
FRONT/
REAR
VIEW
ABCDEFG
0.035 0.300 0.023 0.080 0.186 0.043 0.025