User manual

MPLAB
®
ICD 3 In-Circuit Debugger User’s Guide
DS51766A-page 92 © 2008 Microchip Technology Inc.
MPLAB ICD 2
Microchip’s in-circuit debugger that works with MPLAB IDE. The ICD supports Flash
devices with built-in debug circuitry. The main component of each ICD is the pod. A
complete system consists of a pod, header board (with a device-ICD), target board,
cables, and MPLAB IDE software.
MPLAB ICE 2000
Microchip’s in-circuit debugger that works with MPLAB IDE. MPLAB ICE 2000 supports
8-bit PIC MCUs. The main component of each ICE is the pod. A complete system con-
sists of a pod, processor module, cables, and MPLAB IDE software.
MPLAB ICE 4000
Not recommended for new designs. See the MPLAB ICD 3 in-circuit debugger.
Microchip’s in-circuit debugger that works with MPLAB IDE. MPLAB ICE 4000 supports
PIC18F and PIC24 MCUs and dsPIC DSCs. The main component of each ICE is the
pod. A complete system consists of a pod, processor module, cables, and MPLAB IDE
software.
MPLAB IDE
Microchip’s Integrated Development Environment.
MPLAB LIB30
MPLAB LIB30 archiver/librarian is an object librarian for use with object modules
created using either MPLAB ASM30 or MPLAB C30 C compiler.
MPLAB LINK30
MPLAB LINK30 is an object linker for the Microchip MPLAB ASM30 assembler and the
Microchip MPLAB C30 C compiler.
MPLAB PM3
A device programmer from Microchip. Programs PIC18 microcontrollers and dsPIC
digital signal controllers. Can be used with MPLAB IDE or stand-alone. Will obsolete
PRO MATE II.
MPLAB ICD 3 In-Circuit Debugger
Microchip’s in-circuit debuggers that works with MPLAB IDE. The MPLAB ICD 3
debugger supports PIC18F and PIC24 MCUs and dsPIC DSCs. The main component
of each ICE is the pod. A complete system consists of a pod, a driver (and potentially
a receiver) card, cables, and MPLAB IDE software.
MPLAB SIM
Microchip’s simulator that works with MPLAB IDE in support of PIC MCU and dsPIC
DSC devices.
MPLIB™ Object Librarian
Microchip’s librarian that can work with MPLAB IDE. MPLIB librarian is an object librar-
ian for use with COFF object modules created using either MPASM assembler (mpasm
or mpasmwin v2.0) or MPLAB C17/C18 C compilers.
MPLINK™ Object Linker
MPLINK linker is an object linker for the Microchip MPASM assembler and the Micro-
chip MPLAB C17 or C18 C compilers. MPLINK linker also may be used with the Micro-
chip MPLIB librarian. MPLINK linker is designed to be used with MPLAB IDE, though
it does not have to be.
MRU
Most Recently Used. Refers to files and windows available to be selected from MPLAB
IDE main pull down menus.