User manual

MPLAB

ICD 3 In-Circuit Debugger User’s Guide

10.6.2 Modular Cable and Connector

For standard communications, a modular cable connects the debugger and the target

application. The specifications for this cable and its connectors are listed below.

10.6.2.1 MODULAR CONNECTOR SPECIFICATION

• Manufacturer, Part Number – AMP Incorporated, 555165-1

• Distributor, Part Number – Digi-Key, A9031ND

The following table shows how the modular connector pins on an application corre-

spond to the microcontroller pins. This configuration provides full ICD functionality.

FIGURE 10-2: MODULAR CONNECTOR PINOUT OF TARGET BOARD

10.6.2.2 MODULAR PLUG SPECIFICATION

• Manufacturer, Part Number – AMP Incorporated, 5-554710-3

• Distributor, Part Number – Digi-Key, A9117ND

10.6.2.3 MODULAR CABLE SPECIFICATION

• Manufacturer, Part Number – Microchip Technology, 07-00024

10.7 ICD 3 TEST INTERFACE BOARD

This board can be used to verify that the debugger is functioning properly. To use this

board:

Modular

Connector Pin

Microcontroller

6LVP

5 RB6

4RB7

3 Ground

DD Target

1 VPP

Bottom view of Modular Connector

Pinout on Target Board

Front view of Modular Connector

on Target Board

Pin 1

8.00”

Pin 6