User manual

MPLAB

ICD 3 IN-CIRCUIT

DEBUGGER USER’S GUIDE

Chapter 10. Hardware Specification

10.1 INTRODUCTION

The hardware and electrical specifications of the MPLAB ICD 3 in-circuit debugger

system are detailed.

10.2 HIGHLIGHTS

This chapter discusses:

• Declaration of Conformity

• USB Port/Power

• MPLAB ICD 3 Debugger

• Standard Communication Hardware

• ICD 3 Test Interface Board

• Target Board Considerations

10.3 DECLARATION OF CONFORMITY

Microchip Technology, Inc.

2355 W. Chandler Blvd.

Chandler, Arizona 85224-6199

USA

hereby declare that the product:

MPLAB

ICD 3 In-Circuit Debugger

complies with the following standards, provided that the restrictions stated in the

operating manual are observed:

Standards: EN61010-1 Laboratory Equipment

Microchip Technology, Inc.

Date: August 2006

Important Information Concerning the Use of the MPLAB

ICD 3 In-Circuit Debugger

Due to the special nature of the MPLAB ICD 3 in-circuit debugger, the user is advised

that it can generate higher than normal levels of electromagnetic radiation which can

interfere with the operation of all kinds of radio and other equipment.

To comply with the European Approval Regulations therefore, the following restrictions

must be observed:

1. The development system must be used only in an industrial (or comparable)

area.

2. The system must not be operated within 20 meters of any equipment which may

be affected by such emissions (radio receivers, TVs etc.).