User manual

MPLAB

ICD 3 In-Circuit Debugger User’s Guide

9.5.3 Settings Dialog, Freeze on Halt Tab

Select peripherals to freeze on halt on this tab.

PIC18 MCU Devices

To freeze/unfreeze all device peripherals on halt, check/uncheck the “Freeze on Halt”

checkbox. If this does not halt your desired peripheral, be aware that some peripherals

have no freeze on halt capability and cannot be controlled by the debugger.

dsPIC30F/33F, PIC24F/H and PIC32MX Devices

For peripherals in the list “Peripherals to Freeze on Halt”, check to freeze that periph-

eral on a halt. Uncheck the peripheral to let it run while the program is halted. If you do

not see a peripheral on the list, check “All Other Peripherals”. If this does not halt your

desired peripheral, be aware that some peripherals have no freeze on halt capability

and cannot be controlled by the debugger.

To select all peripherals, including “All Other Peripherals”, click Check All. To deselect

all peripherals, including “All Other Peripherals”, click Uncheck All.

9.5.4 Settings Dialog, Status Tab

View the status of your MPLAB ICD 3 system on this tab.

TABLE 9-8: STATUS ITEMS

Versions

Firmware Suite Version Debugger firmware suite version. The firmware suite consists of

the three items specified below.

FPGA Version Internal FPGA chip firmware version.

Algorithm Plug-in Version Debugger algorithm plug-in version. For your selected device, an

algorithm is used to support the device plugged into the target.

OS Version Debugger operating system version.

Voltages

ICD 3 V

PP Debugger VPP.

ICD 3 VDD Debugger VDD.

Target V

DD VDD sensed at target.

Refresh Voltages Sensing of Status tab items occurs when the tab is achieved. To

see updates otherwise, click this button.