User manual

Debugger Function Summary
© 2008 Microchip Technology Inc. DS51766A-page 69
9.3.1.2 BREAKPOINT DIALOG BUTTONS
Use the buttons to add a breakpoint and set up additional break conditions. Also, a
stopwatch is available for use with breakpoints and triggers.
9.3.2 Set Breakpoint Dialog
Click Add Breakpoint in the Breakpoints Dialog to display this dialog.
Select a breakpoint for the Breakpoints dialog here.
9.3.2.1 PROGRAM MEMORY TAB
Set up a program memory breakpoint here.
Note: Buttons displayed will depend on the selected device.
TABLE 9-2: BREAKPOINT DIALOG BUTTONS
Control Function Related Dialog
Add Breakpoint Add a breakpoint Section 9.3.2 “Set Breakpoint
Dialog”
Stopwatch Set up the stopwatch Section 9.3.3 “Stopwatch Dia-
log”
Event Breakpoints Set up break on an event Section 9.3.4 “Event Break-
points Dialog”
Sequenced Breakpoints Set up a sequence until break Section 9.3.5 “Sequenced
Breakpoints Dialog”
ANDed Breakpoints Set up ANDed condition until
break
Section 9.3.6 “ANDed Break-
points Dialog”
TABLE 9-3: PROGRAM MEMORY BREAKPOINT
Control Function
Address Location of breakpoint in hex
Breakpoint Type The type of program memory breakpoint. See the device data
sheet for more information on table reads/writes.
Program Memory Execution
– break on execution of above
address
TBLRD Program Memory – break on table read of above address
TBLWT Program Memory
– break on table write to above address
Pass Count Break on pass count condition.
Always break
– always break as specified in “Breakpoint type”
Break occurs Count instructions after Event
– wait Count (0-255)
instructions before breaking after event specified in “Breakpoint
type”
Event must occur Count times
– break only after event specified in
“Breakpoint type” occurs Count (0-255) times