Datasheet

DALI Control Device & Control Gear
Demonstration Setup
Program Control Device
 Utilize PICkit3 to program Main Communication Board with
DALI_ControlDevice.X.production.hex to create Controller
Program Control Gear
 Utilize PICkit3 to program (2 or more) Main Communication
Boards with DALI_ControlGear.X.production.hex to create
Receiver
Setup & Attach Adapters
 Set DALI Adapter Jumper Settings
 J1 – ON
 J3 – ON
 J4 – ON
 J5 – ON
 Insert DALI adapters to all Main Communication Boards
Connect Control Device to Control Gear
 Connect Main Communication Boards with DALI adapters in
a “Daisy Chain” configuration with either RJ45 patch cable or
2-wire cables
 Note whether the board is Control Device or Control Gear
Provide Power
 Insert 9-12V DC power cord to Control Device
 Note that power to Control Gear is provided via cabling
“Phantom Power”
1
2
3
5
Control
Device
Control
Gear
Control
Gear
1
2
3
4
5
4