User manual

MPLAB

PM3 User’s Guide

7.5.3 SQTP Tab

Use Serial Quick Turn Programming (SQTP) to program a unique serial number into

each device. This number can be used as an entry code, password or ID number.

Select Programmer>Settings

and click on the SQTP tab to view or set up SQTP

programming for the device (Figure 7-5). Also see Section 7.6.1 “Using SQTP”.

FIGURE 7-5: SQTP TAB

TABLE 7-9: SQTP MENU

Selection Description

Random Select this option to generate unique, random numbers for

each part.

Pseudo-Random

Seed Value (Hex)

Select this option to generate a pseudo-random set of

non-repeating numbers based on the seed value specified.

Sequential

Start Value (Hex)

Increment (Hex)

Select this option to generate sequential numbers based on

the starting value specified and incrementing each number

by the amount specified.

Start Address (Hex) Enter the starting address (in hex) for the serial number.

Number of Words (Dec) Enter the size of the serial number. Make sure a large

enough serial number is specified for the number of parts

planned to program using this file.

Number of Parts (Dec) Enter the number of parts to be programmed using this file.

Generate Opens the Save SQTP File As dialog.