User manual

MPLAB PM3 – MPLAB IDE Reference

7.5.2 Voltages Tab

Select Programmer>Settings and click on the Voltages tab to view or set the voltages

for the device (Figure 7-4).

FIGURE 7-4: VOLTAGES TAB

TABLE 7-4: MEMORY RANGES OPTIONS

Selection Description

Program Memory Start Address Type the start address for the range of program memory

(in hex).

Program Memory End Address Type the end address for the range of program memory

(in hex).

Reset Addresses Click this button to reset the program memory

addresses.

Program Memory Select this check box to program Program Memory. The

program memory range is determined by the Program

memory start and end address fields.

Configuration Bits Select this check box if configuration memory is to be

programmed.

ID Location Select this check box if the ID location is to be

programmed.

EEPROM Data Select this check box if the EEPROM data memory is to

be programmed.

Calibration Memory Select this check box if calibration memory to be

programmed.

Erase All Before Program Select this check box if the device is to be erased before

programming.