User manual

MPLAB

PM3 User’s Guide

Position the mouse pointer over the toolbar item to display the name. Table 7-1 lists the

items on the toolbar.

TABLE 7-1: MPLAB

PM3 TOOLBAR COMMANDS

7.3 CONFIGURE MENU

The Configure Menu is an MPLAB IDE menu used in conjunction with the MPLAB PM3

Programmer Menu. Refer to the MPLAB IDE documentation for detailed information.

The Configure Menu consists of five dialog selections listed in Table 7-2.

TABLE 7-2: CONFIGURE MENU

Symbol Command Description

Blank Check All Checks that the device is completely blank (all bits are set to

‘1’). This will also check that all Configuration bits are set to

‘1’ (unprogrammed state). (Same as Programmer>Blank

Check All.)

Read Reads the device. (Same as Programmer>Read.)

Program Programs the device. (Same as Programmer>Program

Verify Verifies that the device was programmed properly. (Same as

Programmer>Verify

Erase Flash Device Erase all memory on a Flash Device. (Same as

Programmer>Erase Flash Device

Program Statistics Provides the number of programming attempts: passed,

failed and total. To clear the values in this display, select

Programmer>Reset Program Statistics

SQTP File Path Displays the Serial Quick Turn Programming (SQTP) file

path.

Selection Description

Select Device Select the device.

Configuration Bits Select values for the device Configuration bits. Setting these values will

affect both debugger and programmer operation.

External Memory Select whether to use external memory or not. Also specify external

memory range.

ID Memory Enter value into ID memory.

Settings Enter default setting for the workspace, debugger, program loading, hot

keys and project.