User manual

MPLAB

PM3 User’s Guide

2.3.3 Installing a Socket Module or ICSP Cable

Socket modules are sold separately. MPLAB PM3 comes with an 18-inch ICSP cable

for ICSP programming. See Figure 2-2 for location of socket module connectors and

ICSP connector.

FIGURE 2-2: TOP VIEW OF MPLAB

PM3

2.3.3.1 SOCKET MODULE INSTALLATION

Socket modules are available to accommodate each device package. The “Product

Selector Guide” (DS00148) lists Microchip’s devices, tools and socket modules. The

“Development System Ordering Guide” (DS30177) describes the available socket

modules. Also, the Readme for MPLAB PM3 file lists socket module support for each

device.

2.3.3.1.1 For MPLAB PM3 Socket Modules

1. Align the connectors on the socket module with the connectors on MPLAB PM3

(Figure 2-2).

2. Push the socket module down evenly mating the connectors.

It is always a good practice to insert a known blank device and do a Blank Check

whenever the socket module is changed.

2.3.3.1.2 For PRO MATE II Socket Modules

ESC ENTER

STATUS

POWER

MPLAB

PM3

Device Programmer

ICSP Connector

Socket Module Connectors

LEDs

LCD

Keys/Buttons

Note: MPLAB PM3 allows hot swapping of socket modules. If the status LED is

not lit, sockets can be replaced.

Note 1: In order to use PRO MATE II socket modules with MPLAB PM3, you must

obtain an AC164350 adapter kit. See the “Development System Ordering

Guide” (DS30177).

2: The PRO MATE II ICSP socket module is not supported by MPLAB PM3.

An 18-inch ICSP cable is included with MPLAB PM3, eliminating the

need for an ICSP socket.