Datasheet
dsPIC33FJXXXMCX06A/X08A/X10A
DS70594D-page 358 2009-2012 Microchip Technology Inc.
APPENDIX B: REVISION HISTORY
Revision A (May 2009)
This is the initial released version of the document.
Revision B (October 2009)
The revision includes the following global update:
• Added Note 2 to the shaded table that appears at
the beginning of each chapter. This new note
provides information regarding the availability of
registers and their associated bits.
This revision also includes minor typographical and
formatting changes throughout the data sheet text.
All other major changes are referenced by their
respective section in the following table.
TABLE B-1: MAJOR SECTION UPDATES
Section Name Update Description
“16-bit Digital Signal Controllers (up to 256
KB Flash and 30 KB SRAM) with Motor
Control and Advanced Analog”
Added information on high temperature operation (see “Operating
Range:”).
Section 11.0 “I/O Ports” Changed the reference to digital-only pins to 5V tolerant pins in the
second paragraph of Section 11.2 “Open-Drain Configuration”.
Section 20.0 “Universal Asynchronous
Receiver Transmitter (UART)”
Updated the two baud rate range features to: 10 Mbps to 38 bps at
40 MIPS.
Section 22.0 “10-bit/12-bit Analog-to-Digital
Converter (ADC)”
Updated the ADCx block diagram (see Figure 22-1).
Section 23.0 “Special Features” Updated the second paragraph and removed the fourth paragraph in
Section 23.1 “Configuration Bits”.
Updated the Device Configuration Register Map (see Table 23-1).
Section 26.0 “Electrical Characteristics” Updated the Absolute Maximum Ratings for high temperature and
added Note 4.
Updated Power-Down Current parameters DC60d, DC60a, DC60b,
and DC60d (see Table 26-7).
Added I2Cx Bus Data Timing Requirements (Master Mode)
parameter IM51 (see Table 26-40).
Updated the SPIx Module Slave Mode (CKE = 1) Timing
Characteristics (see Figure 26-17).
Updated the Internal LPRC Accuracy parameters (see Table 26-19).
Updated the ADC Module Specifications (12-bit Mode) parameters
AD23a, AD24a, AD23b, and AD24b (see Table 26-46).
Updated the ADC Module Specifications (10-bit Mode) parameters
AD23c, AD24c, AD23d, and AD24d (see Table 26-46).
Section 27.0 “High Temperature Electrical
Characteristics”
Added new chapter with high temperature specifications.
“Product Identification System” Added the “H” definition for high temperature.