Datasheet

 2009-2012 Microchip Technology Inc. DS70591E-page 371
dsPIC33FJ32GS406/606/608/610 and dsPIC33FJ64GS406/606/608/610
TABLE 27-7: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
-40°C  TA  +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (IPD)
(2,4)
DC60d 50 200 A -40°C
3.3V Base Power-Down Current
DC60a 50 200 A +25°C
DC60b 200 500 A +85°C
DC60c 600 1000 A +125°C
DC61d 8 13 A -40°C
3.3V Watchdog Timer Current: I
WDT
(3)
DC61a 10 15 A +25°C
DC61b 12 20 A +85°C
DC61c 13 25 A +125°C
Note 1: Data in the Typical column is at 3.3V, +25°C unless otherwise stated.
2: I
PD (Sleep) current is measured as follows:
• CPU core is off, oscillator is configured in EC mode and external clock is active, OSC1 is driven with
external square wave from rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration Word
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled
• All peripheral modules are disabled (all PMDx bits are all ‘1’s)
• The VREGS bit (RCON<8>) = 0 (i.e., core regulator is set to standby while the device is in Sleep
mode)
• JTAG disabled
3: The  current is the additional current consumed when the WDT module is enabled. This current should
be added to the base I
PD current.
4: These currents are measured on the device containing the most memory in this family.