Datasheet
dsPIC33FJ32GS406/606/608/610 and dsPIC33FJ64GS406/606/608/610
DS70591E-page 368 2009-2012 Microchip Technology Inc.
TABLE 27-5: DC CHARACTERISTICS: OPERATING CURRENT (IDD)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C T
A +85°C for Industrial
-40°C T
A +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Operating Current (IDD)
(2)
DC20d 21 30 mA -40°C
3.3V
10 MIPS
See Note 2
DC20a 21 30 mA +25°C
DC20b 21 30 mA +85°C
DC20c 22 30 mA +125°C
DC21d 28 40 mA -40°C
3.3V
16 MIPS
See Note 2 and 3
DC21a 28 40 mA +25°C
DC21b 28 40 mA +85°C
DC21c 29 40 mA +125°C
DC22d 35 45 mA -40°C
3.3V
20 MIPS
See Note 2 and 3
DC22a 35 45 mA +25°C
DC22b 35 45 mA +85°C
DC22c 36 45 mA +125°C
DC23d 49 60 mA -40°C
3.3V
30 MIPS
See Note 2 and 3
DC23a 49 60 mA +25°C
DC23b 49 60 mA +85°C
DC23c 50 60 mA +125°C
DC24d 66 75 mA -40°C
3.3V
40 MIPS
See Note 2
DC24a 66 75 mA +25°C
DC24b 66 75 mA +85°C
DC24c 67 75 mA +125°C
DC25d 153 170 mA -40°C
3.3V
40 MIPS
See Note 2 and 3, except PWM is
operating at maximum speed
(PTCON2 = 0x0000)
DC25a 154 170 mA +25°C
DC25b 155 170 mA +85°C
DC25c 156 170 mA +125°C
Note 1: Data in “Typical” column is at 3.3V, +25°C unless otherwise stated.
2: I
DD is primarily a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact
on the current consumption. The test conditions for all I
DD measurements are as follows:
• Oscillator is configured in EC mode with PLL, OSC1 is driven with external square wave from
rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration Word
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled
• CPU, SRAM, program memory and data memory are operational
• No peripheral modules are operating; however, every peripheral is being clocked (all PMDx bits are all ‘0’s)
• CPU executing while(1) statement
• JTAG disabled
3: These parameters are characterized but not tested in manufacturing.