Datasheet

ManualsBrandsMICROCHIP TECHNOLOGY ManualsMicrocontrollers, Microprocessors & QuartzesEmbedded microcontroller TQFP 64 (10x10) 16-Bit 40 null I/O number 58

251

252

253

254

255

256

257

258

259

260

 2009-2012 Microchip Technology Inc. DS70591E-page 251

dsPIC33FJ32GS406/606/608/610 and dsPIC33FJ64GS406/606/608/610

bit 9 CLPOL: Current-Limit Polarity for PWM Generator # bit

(1)

1 = The selected current-limit source is active-low

0 = The selected current-limit source is active-high

bit 8 CLMOD: Current-Limit Mode Enable for PWM Generator # bit

1 = Current-Limit mode is enabled

0 = Current-Limit mode is disabled

bit 7-3 FLTSRC<4:0>: Fault Control Signal Source Select for PWM Generator # bits

(2,3)

11111 = Reserved

11110 = Fault 23

11101 = Fault 22

11100 = Fault 21

11011 = Fault 20

11010 = Fault 19

11001 = Fault 18

11000 = Fault 17

10111 = Fault 16

10110 = Fault 15

10101 = Fault 14

10100 = Fault 13

10011 = Fault 12

10010 = Fault 11

10001 = Fault 10

10000 = Fault 9

01111 = Fault 8

01110 = Fault 7

01101 = Fault 6

01100 = Fault 5

01011 = Fault 4

01010 = Fault 3

01001 = Fault 2

01000 = Fault 1

00111 = Reserved

00110 = Reserved

00101 = Reserved

00100 = Reserved

00011 = Analog Comparator 4

00010 = Analog Comparator 3

00001 = Analog Comparator 2

00000 = Analog Comparator 1

bit 2 FLTPOL: Fault Polarity for PWM Generator # bit

(1)

1 = The selected Fault source is active-low

0 = The selected Fault source is active-high

bit 1-0 FLTMOD<1:0>: Fault Mode for PWM Generator # bits

11 = Fault input is disabled

10 = Reserved

01 = The selected Fault source forces PWMxH, PWMxL pins to FLTDAT values (cycle)

00 = The selected Fault source forces PWMxH, PWMxL pins to FLTDAT values (latched condition)

Note 1: These bits should be changed only when PTEN (PTCON<15>) = 0.

2: When Independent Fault mode is enabled (IFLTMOD = 1) and Fault 1 is used for Current-Limit mode

(CLSRC<4:0> = b0000), the Fault Control Source Select bits (FLTSRC<4:0>) should be set to an unused

Fault source to prevent Fault 1 from disabling both the PWMxL and PWMxH outputs.

3: When Independent Fault mode is enabled (IFLTMOD = 1) and Fault 1 is used for Fault mode

(FLTSRC<4:0> = b0000), the Current-Limit Control Source Select bits (CLSRC<4:0>) should be set to an unused

current-limit source to prevent the current-limit source from disabling both the PWMxH and PWMxL outputs.