Datasheet

dsPIC33FJ32GS406/606/608/610 and dsPIC33FJ64GS406/606/608/610
DS70591E-page 414  2009-2012 Microchip Technology Inc.
28.1 DC Characteristics
TABLE 28-1: OPERATING MIPS vs. VOLTAGE
Characteristic
V
DD Range
(in Volts)
Temp Range
(in °C)
Max MIPS
dsPIC33FJ32GS406/606/608/610 and
dsPIC33FJ64GS406/606/608/610
— 3.0-3.6V
(1)
-40°C to +85°C 50
Note 1: Overall functional device operation at V
BORMIN < VDD < VDDMIN is tested but not characterized. All device
analog modules, such as the ADC, etc., will function but with degraded performance below V
DDMIN. See
Parameter BO10 in Table 27-11 for the BOR values.
TABLE 28-2: DC CHARACTERISTICS: OPERATING CURRENT (IDD)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
Parameter
No.
Typical Max Units Conditions
Operating Current (I
DD)
(1)
MDC29d 85 100 mA -40°C
3.3V 50 MIPSMDC29a 85 100 mA +25°C
MDC29b 85 100 mA +85°C
Note 1: I
DD is primarily a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact
on the current consumption. The test conditions for all I
DD measurements are as follows:
• Oscillator is configured in EC mode with PLL, OSC1 is driven with external square wave from
rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration Word
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled
• CPU, SRAM, program memory and data memory are operational
• No peripheral modules are operating; however, every peripheral is being clocked (all PMDx bits are
zeroed)
• CPU executing while(1) statement
• JTAG is disabled