Datasheet

© 2007-2012 Microchip Technology Inc. DS70292G-page 341
dsPIC33FJ32GP302/304, dsPIC33FJ64GPX02/X04, AND dsPIC33FJ128GPX02/X04
TABLE 30-6: DC CHARACTERISTICS: IDLE CURRENT (IIDLE)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C ≤T
A ≤+125°C for Extended
Parameter
No.
(3)
Typical
(2)
Max Units Conditions
Idle Current (IIDLE): Core OFF Clock ON Base Current
(1)
DC40d 8 10 mA -40°C
3.3V
10 MIPS
DC40a 8 10 mA +25°C
DC40b 9 10 mA +85°C
DC40c 10 13 mA +125°C
DC41d 13 15 mA -40°C
3.3V 16 MIPS
DC41a 13 mA +25°C15
DC41b 13 16 mA +85°C
DC41c 13 19 mA +125°C
DC42d 15 18 mA -40°C
3.3V 20 MIPS
DC42a 16 18 mA +25°C
DC42b 16 19 mA +85°C
DC42c 17 22 mA +125°C
DC43a 23 27 mA +25°C
3.3V 30 MIPS
23 26DC43d mA -40°C
DC43b 24 28 mA +85°C
DC43c 25 31 mA +125°C
DC44d 31 42 mA -40°C
3.3V 40 MIPS
DC44a 31 36 mA +25°C
DC44b 32 39 mA +85°C
DC44c 34 43 mA +125°C
Note 1: Base I
IDLE current is measured as follows:
• CPU core is off (i.e., Idle mode), oscillator is configured in EC mode and external clock active, OSC1
is driven with external square wave from rail-to-rail (EC clock overshoot/undershoot < 250 mV
required)
• CLKO is configured as an I/O input pin in the Configuration word
• External Secondary Oscillator disabled (i.e., SOSCO and SOSCI pins configured as digital I/O inputs)
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled
• No peripheral modules are operating; however, every peripheral is being clocked (defined PMDx bits
are set to zero)
• JTAG is disabled
2: Data in “Typ” column is at 3.3V, +25ºC unless otherwise stated.
3: These parameters are characterized but not tested in manufacturing.