Datasheet

 2011-2012 Microchip Technology Inc. DS70652E-page 191
dsPIC33FJ16(GP/MC)101/102 AND dsPIC33FJ32(GP/MC)101/102/104
REGISTER 15-10: PxFLTBCON: PWMx FAULT B CONTROL REGISTER
(1,2,3,4)
U-0 U-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0
— — FBOV3H FBOV3L FBOV2H FBOV2L FBOV1H FBOV1L
bit 15 bit 8
R/W-0 U-0 U-0 U-0 U-0 R/W-1 R/W-1 R/W-1
FLTBM
— — — — FBEN3 FBEN2 FBEN1
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15-14 Unimplemented: Read as ‘0’
bit 13-8 FBOVxH<3:1>:FBOVxL<3:1>: Fault Input B PWM Override Value bits
1 = The PWM output pin is driven active on an external Fault input event
0 = The PWM output pin is driven inactive on an external Fault input event
bit 7 FLTBM: Fault B Mode bit
1 = The Fault B input pin functions in the Cycle-by-Cycle mode
0 = The Fault B input pin latches all control pins to the programmed states in PxFLTBCON<13:8>
bit 6-3 Unimplemented: Read as ‘0’
bit 2 FBEN3: Fault Input B Enable bit
1 = PWMxH3/PWMxL3 pin pair is controlled by Fault Input B
0 = PWMxH3/PWMxL3 pin pair is not controlled by Fault Input B
bit 1 FBEN2: Fault Input B Enable bit
1 = PWMxH2/PWMxL2 pin pair is controlled by Fault Input B
0 = PWMxH2/PWMxL2 pin pair is not controlled by Fault Input B
bit 0 FBEN1: Fault Input B Enable bit
1 = PWMxH1/PWMxL1 pin pair is controlled by Fault Input B
0 = PWMxH1/PWMxL1 pin pair is not controlled by Fault Input B
Note 1: Comparator outputs are not internally connected to the PWM Fault control logic. If using the Comparator
modules for Fault generation, the user must externally connect the desired comparator output pin to the
dedicated FLTA1 or FLTB1 input pin.
2: Refer to Table 15-1 for FLT
B1 implementation details.
3: The PxFLTACON register is a write-protected register. Refer to Section 15.3 “Write-Protected Registers”
for more information on the unlock sequence.
4: During any Reset event, FLTB1
is enabled by default and must be cleared as described in Section 15.2
“PWM Faults”.