Datasheet

© 2007-2011 Microchip Technology Inc. DS70264E-page 163
dsPIC33FJ12GP201/202
18.0 10-BIT/12-BIT
ANALOG-TO-DIGITAL
CONVERTER (ADC)
Microchip dsPIC33FJ12GP201/202 devices have up to
10 ADC module input channels.
The AD12B bit (AD1CON1<10>) allows each of the
ADC modules to be configured as either a 10-bit,
4-sample-and-hold ADC (default configuration), or a
12-bit, 1-sample-and-hold ADC.
18.1 Key Features
The 10-bit ADC configuration has the following key
features:
• Successive Approximation (SAR) conversion
• Conversion speeds of up to 1.1 Msps
• Up to 10 analog input pins
• External voltage reference input pins
• Simultaneous sampling of up to four analog input
pins
• Automatic Channel Scan mode
• Selectable conversion trigger source
• Selectable Buffer Fill modes
• Four result alignment options (signed/unsigned,
fractional/integer)
• Operation during CPU Sleep and Idle modes
• 16-word bit conversion result buffer
The 12-bit ADC configuration supports all the above
features, except:
• In the 12-bit configuration, conversion speeds of
up to 500 ksps are supported
• There is only one sample-and-hold amplifier in the
12-bit configuration, so simultaneous sampling of
multiple channels is not supported
Depending on the particular device pinout, the ADC
can have up to 10 analog input pins, designated AN0
through AN9. In addition, there are two analog input
pins for external voltage reference connections. These
voltage reference inputs can be shared with other
analog input pins.
The actual number of analog input pins and external
voltage reference input configuration depend on the
specific device.
Block diagrams of the ADC module are shown in
Figure 18-1 and Figure 18-2.
18.2 ADC Initialization
To configure the ADC module:
1. Select port pins as analog inputs
(AD1PCFGH<15:0> or AD1PCFGL<15:0>).
2. Select voltage reference source to match
expected range on analog inputs
(AD1CON2<15:13>).
3. Select the analog conversion clock to match
desired data rate with processor clock
(AD1CON3<7:0>).
4. Determine how many sample-and-hold chan-
nels will be used (AD1CON2<9:8> and
AD1PCFGH<15:0> or AD1PCFGL<15:0>).
5. Select the appropriate sample/conversion
sequence (AD1CON1<7:5> and
AD1CON3<12:8>).
6. Select the way conversion results are presented
in the buffer (AD1CON1<9:8>).
a) Turn on the ADC module (AD1CON1<15>).
7. Configure ADC interrupt (if required):
a) Clear the AD1IF bit.
b) Select ADC interrupt priority.
Note 1: This data sheet summarizes the features
of the dsPIC33FJ12GP201/202 family of
devices. It is not intended to be a
comprehensive reference source. To
complement the information in this data
sheet, refer to Section 16.
“Analog-to-Digital Converter (ADC)”
(DS70183) of the “dsPIC33F/PIC24H
Family Reference Manual”, which is
available on the Microchip website
(www.microchip.com).
2: Some registers and associated bits
described in this section may not be
available on all devices. Refer to
Section 4.0 “Memory Organization” in
this data sheet for device-specific register
and bit information.
Note: The ADC module must be disabled before
the AD12B bit can be modified.