Datasheet

 2011-2012 Microchip Technology Inc. DS75018C-page 339
dsPIC33FJ06GS001/101A/102A/202A and dsPIC33FJ09GS302
APPENDIX A: REVISION HISTORY
Revision A (July 2011)
This is the initial released version of this document.
Revision B (February 2012)
This revision includes formatting changes and minor
typographical updates throughout the data sheet text.
Where applicable, new sections were added to each
peripheral chapter that provide information and links to
related resources, as well as helpful tips. For
examples, see Section 18.1 “UART Helpful Tips”
and Section 18.1 “UART Helpful Tips”.
The data sheet status was updated from Advance
Information to Preliminary.
In addition, all occurrences to the package known as
TLA were updated to VTLA.
All other major changes are referenced by their
respective section in Table A-1.
TABLE A-1: MAJOR SECTION UPDATES
Section Name Update Description
“16-Bit Microcontrollers and
Digital Signal Controllers with
High-Speed PWM, ADC and
Comparators”
The previous content was reorganized and is now presented as the first page of
the data sheet.
Relocated the Referenced Sources content, which was previously presented in
Section 1.0 “Device Overview”.
Section 2.0 “Guidelines for
Getting Started with 16-Bit
Digital Signal Controllers”
Updated the Recommended Minimum Connection diagram (see Figure 2-1).
Section 4.0 “Memory
Organization”
Updated the Program Memory Map (see Figure 4-1).
Updated bits 10-8 in IPC27 of the Interrupt Controller Register Map for
dsPIC33FJ06GS001 Devices (see Table 4-4).
Renamed the CHOPCLK<6:0> bits in the CHOP register to: CHOP<6:0> in the
High-Speed PWM Register Map (see Ta ble 4 - 1 2 ).
Removed RPINR11 from the Peripheral Pin Select Input Register Map for the
dsPIC33FJ06GS001 Device (see Table 4-24).
Added the REFOMD bit to PMD4 in the PMD Register Map for the
dsPIC33FJ06GS001 device (see Table 4-34).
Section 21.0 “Constant Current
Source”
Added the Current Source Calibration bits (ISRCCAL<5:0>) to the Current
Source Control register (see Register 21-1).
Section 22.0 “Special Features” Added the Constant Current Source Calibration Register (see Register 22-1).
Section 25.0 “Electrical
Characteristics”
Updated the Absolute Maximum Ratings(1).
Added Note 1 to the Operating MIPS vs. Voltage specification (see Ta bl e 25 -1 ).
Updated all DC Characteristics: I/O Pin Output Specifications (see Table 25-10).
Updated the typical value for Parameters F20a and F20b in the Internal FRC
Accuracy specification (see Table 25-19).
Updated the minimum and maximum values for Parameter TA20, and the
minimum value for Parameter TA11 in the Timer1 External Clock Timing
Requirements (see Table 25-23).
Updated the OC/PWM Module Timing Characteristics diagram (see Figure 25-8).
Updated the minimum and maximum values for the Simple OC/PWM Mode
Timing Requirements (see Table 25-27).
Added Note 4 and Note 5 to the 10-Bit, High-Speed ADC Module Specifications
(see Table 25-39).
Section 26.0 “DC and AC
Device Characteristics Graphs”
Added new chapter.