Datasheet

 2011-2012 Microchip Technology Inc. DS75018C-page 311
dsPIC33FJ06GS001/101A/102A/202A and dsPIC33FJ09GS302
TABLE 25-41: HIGH-SPEED ANALOG COMPARATOR MODULE SPECIFICATIONS
DC CHARACTERISTICS
(2)
Standard Operating Conditions (unless otherwise stated)
Operating temperature: -40°C  TA  +85°C for Industrial
-40°C  TA  +125°C for Extended
Param. Symbol Characteristic Min. Typ. Max. Units Comments
CM10 V
IOFF Input Offset Voltage -58 +14/-40 66 mV
CM11 VICM Input Common-Mode
Voltage Range
(1)
0—AVDD V
CM14 TRESP Large Signal Response 21 30 49 ns V+ input step of 100 mv while
V- input held at AVDD/2. Delay
measured from analog input pin to
PWM output pin.
Note 1: These parameters are for design guidance only and are not tested in manufacturing.
2: Overall functional device operation at V
BORMIN < VDD < VDDMIN is tested, but not characterized. All device
analog modules, such as the ADC, etc., will function but with degraded performance below VDDMIN. Refer
to Parameter BO10 in Table 25-11 for BOR values.
TABLE 25-42: DAC MODULE SPECIFICATIONS
AC and DC CHARACTERISTICS
(2)
Standard Operating Conditions (unless otherwise stated)
Operating temperature: -40°C  T
A  +85°C for Industrial
-40°C  TA  +125°C for Extended
Param. Symbol Characteristic Min. Typ. Max. Units Comments
DA01 EXTREF External Voltage Reference
(1)
0—AVDD – 1.6 V
DA08 INTREF Internal Voltage Reference
(1)
1.15 1.25 1.35 V
DA02 CVRES Resolution 10 Bits
DA03 INL Integral Nonlinearity Error -7 -1 +7 LSB AV
DD = 3.3V,
DACREF = (AVDD/2)V
DA04 DNL Differential Nonlinearity Error -5 -0.5 +5 LSB
DA05 EOFF Offset Error 0.4 -0.8 2.6 %
DA06 EG Gain Error 0.4 -1.8 5.2 %
DA07 T
SET Settling Time
(1)
711 1551 2100 ns Measured when
RANGE = 1 (high range)
and the CMREF<9:0> bits
transition from 0x1FF to
0x300
Note 1: Parameters are for design guidance only and are not tested in manufacturing.
2: Overall functional device operation at V
BORMIN < VDD < VDDMIN is tested but not characterized. All device
analog modules such as the ADC, etc., will function but with degraded performance below V
DDMIN. Refer to
Parameter BO10 in Table 25-11 for BOR values.