Datasheet

 2011-2012 Microchip Technology Inc. DS75018C-page 279
dsPIC33FJ06GS001/101A/102A/202A and dsPIC33FJ09GS302
IICL Input Low Injection Current
DI60a 0 — -5
(5,8)
mA All pins except VDD, VSS,
AV
DD, AVSS, MCLR,
V
CAP and RB5
I
ICH Input High Injection Current
DI60b 0 — +5
(6,7,8)
mA All pins except VDD, VSS,
AV
DD, AVSS, MCLR,
VCAP, RB5 and digital 5V
tolerant designated pins
IICT Total Input Injection Current
DI60c (sum of all I/O and control pins) -20
(9)
—+20
(9)
mA Absolute instantaneous
sum of all ± input
injection currents from
all I/O pins
(| I
ICL + | IICH |)  
IICT
TABLE 25-9: DC CHARACTERISTICS: I/O PIN INPUT SPECIFICATIONS (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Param. Symbol Characteristic Min. Typ.
(1)
Max. Units Conditions
Note 1: Data in “Typ” column is at 3.3V, +25°C unless otherwise stated.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: See the “Pin Diagrams” section for the list of 5V tolerant I/O pins.
5: V
IL source < (VSS – 0.3); characterized but not tested.
6: Non-5V tolerant pins VIH source > (VDD + 0.3), 5V tolerant pins VIH source > 5.5V; characterized but not
tested.
7: Digital 5V tolerant pins cannot tolerate any “positive” input injection current from input sources > 5.5V.
8: Injection currents > | 0 | can affect the ADC results by approximately 4-6 counts.
9: Any number and/or combination of I/O pins, not excluded under I
ICL or IICH conditions, are permitted
provided the mathematical “absolute instantaneous” sum of the input injection currents from all pins do not
exceed the specified limit; characterized but not tested.