Datasheet

dsPIC33FJ06GS001/101A/102A/202A and dsPIC33FJ09GS302
DS75018C-page 276  2011-2012 Microchip Technology Inc.
TABLE 25-7: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Param. Typical
(1)
Max. Units Conditions
Power-Down Current (I
PD)
(2,4)
DC60d 125 500 A -40°C
3.3V Base Power-Down Current
DC60a 135 500 A +25°C
DC60b 235 500 A +85°C
DC60c 565 950 A +125°C
DC61d 40 50 A -40°C
3.3V Watchdog Timer Current: I
WDT
(3)
DC61a 40 50 A +25°C
DC61b 40 50 A +85°C
DC61c 80 90 A +125°C
Note 1: Data in the Typical column is at 3.3V, +25°C unless otherwise stated.
2: I
PD current is measured as follows:
• CPU core is off, oscillator is configured in EC mode, OSC1 is driven with external square wave from
rail-to-rail
• CLKO is configured as an I/O input pin in the Configuration Word
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled
• All peripheral modules are disabled (PMDx bits are all ‘1’s)
• VREGS bit (RCON<8>) = 1 (i.e., core regulator is set to standby while the device is in Sleep mode)
3: The  current is the additional current consumed when the WDT module is enabled. This current should
be added to the base I
PD current.
4: These currents are measured on the device containing the most memory in this family.