Datasheet

© 2008-2012 Microchip Technology Inc. DS70318F-page 289
dsPIC33FJ06GS101/X02 and dsPIC33FJ16GSX02/X04
DC27d 111 140 mA -40°C
3.3V
40 MIPS
See Note 2, except PWM is
operating at 1/4 speed
(PTCON2 = 0x0002)
DC27a 108 130 mA +25°C
DC27b 105 130 mA +85°C
DC27c 103 130 mA +125°C
DC28d 102 130 mA -40°C
3.3V
40 MIPS
See Note 2, except PWM is
operating at 1/8 speed
(PTCON2 = 0x0003)
DC28a 100 120 mA +25°C
DC28b 100 120 mA +85°C
DC28c 100 120 mA +125°C
TABLE 24-5: DC CHARACTERISTICS: OPERATING CURRENT (IDD) (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for Industrial
-40°C ≤ T
A ≤ +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Operating Current (I
DD)
(2)
Note 1: Data in “Typical” column is at 3.3V, +25°C unless otherwise stated.
2: IDD is primarily a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact
on the current consumption. The test conditions for all I
DD measurements are as follows:
• Oscillator is configured in EC mode with PLL, OSC1 is driven with external square wave from
rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration word
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled
• CPU, SRAM, program memory and data memory are operational
• No peripheral modules are operating; however, every peripheral is being clocked (all PMDx bits are
zeroed)
• CPU executing while(1) statement
• JTAG disabled
3: These parameters are characterized but not tested in manufacturing.