Datasheet

 2009-2012 Microchip Technology Inc. DS70616G-page 549
dsPIC33EPXXX(GP/MC/MU)806/810/814 and PIC24EPXXX(GP/GU)810/814
TABLE 32-48: SPI2 SLAVE MODE (FULL-DUPLEX, CKE = 0, CKP = 0, SMP = 0) TIMING
REQUIREMENTS
AC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Param. Symbol Characteristic
(1)
Min. Typ.
(2)
Max. Units Conditions
SP70 TscP Maximum SCKx Input Frequency — — 11 MHz See Note 3
SP72 TscF SCKx Input Fall Time — — — ns See Parameter DO32
and Note 4
SP73 TscR SCKx Input Rise Time — — — ns See Parameter DO31
and Note 4
SP30 TdoF SDOx Data Output Fall Time — — — ns See Parameter DO32
and Note 4
SP31 TdoR SDOx Data Output Rise Time — — — ns See Parameter DO31
and Note 4
SP35 TscH2doV,
TscL2doV
SDOx Data Output Valid after
SCKx Edge
— 6 20 ns
SP36 TdoV2scH,
TdoV2scL
SDOx Data Output Setup to
First SCKx Edge
30 — — ns
SP40 TdiV2scH,
TdiV2scL
Setup Time of SDIx Data Input
to SCKx Edge
30 — — ns
SP41 TscH2diL,
TscL2diL
Hold Time of SDIx Data Input
to SCKx Edge
30 — — ns
SP50 TssL2scH,
TssL2scL
SSx
 to SCKx  or SCKx 
Input
120 — — ns
SP51 TssH2doZ SSx
 to SDOx Output,
High-Impedance
10 — 50 ns See Note 4
SP52 TscH2ssH,
TscL2ssH
SSx
after SCKx Edge 1.5 TCY + 40 — — ns See Note 4
Note 1: These parameters are characterized, but are not tested in manufacturing.
2: Data in “Typ” column is at 3.3V, +25°C unless otherwise stated.
3: The minimum clock period for SCKx is 91 ns. Therefore, the SCKx clock generated by the master must not
violate this specification.
4: Assumes 50 pF load on all SPIx pins.