Datasheet

 2009-2012 Microchip Technology Inc. DS70616G-page 503
dsPIC33EPXXX(GP/MC/MU)806/810/814 and PIC24EPXXX(GP/GU)810/814
TABLE 32-6: DC CHARACTERISTICS: IDLE CURRENT (IIDLE)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial
-40°C  TA  +125°C for Extended
Param.
(2)
Typ.
(3)
Max. Units Conditions
Idle Current (I
IDLE)
(1)
DC40d 6 10 mA -40°C
3.3V
10 MIPS
DC40a 7 12 mA +25°C
DC40b 8 13 mA +85°C
DC40c 9 15 mA +125°C
DC42d 11 18 mA -40°C
3.3V 20 MIPS
DC42a 12 20 mA +25°C
DC42b 13 21 mA +85°C
DC42c 15 24 mA +125°C
DC44d 23 37 mA -40°C
3.3V 40 MIPS
DC44a 24 39 mA +25°C
DC44b 25 40 mA +85°C
DC44c 27 44 mA +125°C
DC45d 34 55 mA -40°C
3.3V 60 MIPS
DC45a 35 56 mA +25°C
DC45b 36 58 mA +85°C
DC45c 38 61 mA +125°C
DC46d 39 63 mA -40°C
3.3V 70 MIPSDC46a 41 66 mA +25°C
DC46b 42 68 mA +85°C
Note 1: Base I
IDLE current is measured as follows:
• CPU core is off, oscillator is configured in EC mode and external clock is active, OSC1 is driven with
external square wave from rail-to-rail (EC Clock Overshoot/Undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration Word
• External Secondary Oscillator (SOSC) is disabled (i.e., SOSCO and SOSCI pins are configured as
digital I/O inputs)
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled
• No peripheral modules are operating; however, every peripheral is being clocked (defined PMDx bits
are set to zero and unimplemented PMDx bits are set to one)
• The NVMSIDL bit (NVMCON<12>) = 1 (i.e., Flash regulator is set to stand-by while the device is in
Idle mode)
• JTAG is disabled
2: These parameters are characterized but not tested in manufacturing.
3: Data in “Typ” column is at 3.3V, +25ºC unless otherwise stated.