Datasheet

dsPIC33EPXXXGP50X, dsPIC33EPXXXMC20X/50X AND PIC24EPXXXGP/MC20X
DS70000657H-page 340  2011-2013 Microchip Technology Inc.
24.3 PTG Control Registers
REGISTER 24-1: PTGCST: PTG CONTROL/STATUS REGISTER
R/W-0 U-0 R/W-0 R/W-0 U-0 R/W-0 R/W-0 R/W-0
PTGEN — PTGSIDL PTGTOGL —PTGSWT
(2)
PTGSSEN
(3)
PTGIVIS
bit 15 bit 8
R/W-0 HS-0 U-0 U-0 U-0 U-0 R/W-0
PTGSTRT PTGWDTO
— — — —PTGITM1
(1)
PTGITM0
(1)
bit 7 bit 0
Legend: HS = Hardware Settable bit
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15 PTGEN: Module Enable bit
1 = PTG module is enabled
0 = PTG module is disabled
bit 14 Unimplemented: Read as ‘0’
bit 13 PTGSIDL: PTG Stop in Idle Mode bit
1 = Discontinues module operation when device enters Idle mode
0 = Continues module operation in Idle mode
bit 12 PTGTOGL: PTG TRIG Output Toggle Mode bit
1 = Toggle state of the PTGOx for each execution of the PTGTRIG command
0 = Each execution of the PTGTRIG command will generate a single PTGOx pulse determined by the
value in the PTGPWDx bits
bit 11 Unimplemented: Read as ‘0’
bit 10 PTGSWT: PTG Software Trigger bit
(2)
1 = Triggers the PTG module
0 = No action (clearing this bit will have no effect)
bit 9 PTGSSEN: PTG Enable Single-Step bit
(3)
1 = Enables Single-Step mode
0 = Disables Single-Step mode
bit 8 PTGIVIS: PTG Counter/Timer Visibility Control bit
1 = Reads of the PTGSDLIM, PTGCxLIM or PTGTxLIM registers return the current values of their
corresponding counter/timer registers (PTGSD, PTGCx, PTGTx)
0 = Reads of the PTGSDLIM, PTGCxLIM or PTGTxLIM registers return the value previously written
to those limit registers
bit 7 PTGSTRT: PTG Start Sequencer bit
1 = Starts to sequentially execute commands (Continuous mode)
0 = Stops executing commands
bit 6 PTGWDTO: PTG Watchdog Timer Time-out Status bit
1 = PTG Watchdog Timer has timed out
0 = PTG Watchdog Timer has not timed out.
bit 5-2 Unimplemented: Read as ‘0’
Note 1: These bits apply to the PTGWHI and PTGWLO commands only.
2: This bit is only used with the PTGCTRL step command software trigger option.
3: Use of the PTG Single-Step mode is reserved for debugging tools only.