Datasheet

 2011-2013 Microchip Technology Inc. DS70657G-page 409
dsPIC33EPXXXGP50X, dsPIC33EPXXXMC20X/50X AND PIC24EPXXXGP/MC20X
TABLE 30-12: DC CHARACTERISTICS: I/O PIN OUTPUT SPECIFICATIONS
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Param. Symbol Characteristic Min. Typ. Max. Units Conditions
DO10 V
OL Output Low Voltage
4x Sink Driver Pins
(2)
——0.4VVDD = 3.3V,
I OL  6 mA, -40°C  T A  +85°C
I
OL  5 mA, +85°C  T A  +125°C
Output Low Voltage
8x Sink Driver Pins
(3)
——0.4VVDD = 3.3V,
I OL  12 mA, -40°C  T A  +85°C
I
OL  8 mA, +85°C  T A  +125°C
DO20 VOH Output High Voltage
4x Source Driver Pins
(2)
2.4 — — V IOH  -10 mA, VDD = 3.3V
Output High Voltage
8x Source Driver Pins
(3)
2.4 — — V IOH  -15 mA, VDD = 3.3V
DO20A V
OH1 Output High Voltage
4x Source Driver Pins
(2)
1.5
(1)
—— VIOH  -14 mA, VDD = 3.3V
2.0
(1)
—— IOH  -12 mA, VDD = 3.3V
3.0
(1)
—— IOH  -7 mA, VDD = 3.3V
Output High Voltage
8x Source Driver Pins
(3)
1.5
(1)
—— VIOH  -22 mA, VDD = 3.3V
2.0
(1)
—— IOH  -18 mA, VDD = 3.3V
3.0
(1)
—— IOH  -10 mA, VDD = 3.3V
Note 1: Parameters are characterized but not tested.
2: Includes all I/O pins that are not 8x Sink Driver pins (see below).
3: Includes the following pins:
For devices with less than 64 pins: RA3, RA4, RA9, RB<7:15> and RC3
For 64-pin devices: RA4, RA9, RB<7:15>, RC3 and RC15
TABLE 30-13: ELECTRICAL CHARACTERISTICS: BOR
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
(1)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Param
No.
Symbol Characteristic Min.
(2)
Typ. Max. Units Conditions
BO10 V
BOR BOR Event on VDD Transition
High-to-Low
2.65 — 2.95 V VDD
(Notes 2 and 3)
Note 1: Device is functional at V
BORMIN < VDD < VDDMIN, but will have degraded performance. Device functionality
is tested, but not characterized. Analog modules (ADC, op amp/comparator and comparator voltage
reference) may have degraded performance.
2: Parameters are for design guidance only and are not tested in manufacturing.
3: The V
BOR specification is relative to VDD.