Datasheet

 2011-2013 Microchip Technology Inc. DS70657G-page 403
dsPIC33EPXXXGP50X, dsPIC33EPXXXMC20X/50X AND PIC24EPXXXGP/MC20X
TABLE 30-7: DC CHARACTERISTICS: IDLE CURRENT (IIDLE)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  T
A  +125°C for Extended
Parameter
No.
Typ. Max. Units Conditions
Idle Current (I
IDLE)
(1)
DC40d 3 8 mA -40°C
3.3V 10 MIPS
DC40a 3 8 mA +25°C
DC40b 3 8 mA +85°C
DC40c 3 8 mA +125°C
DC42d 6 12 mA -40°C
3.3V 20 MIPS
DC42a 6 12 mA +25°C
DC42b 6 12 mA +85°C
DC42c 6 12 mA +125°C
DC44d 11 18 mA -40°C
3.3V 40 MIPS
DC44a 11 18 mA +25°C
18DC44b 11 mA +85°C
18DC44c 11 mA +125°C
DC45d 17 27 mA -40°C
3.3V 60 MIPS
DC45a 17 27 mA +25°C
27DC45b 17 mA +85°C
27DC45c 17 mA +125°C
DC46d 20 35 mA -40°C
3.3V 70 MIPSDC46a 20 35 mA +25°C
35DC46b 20 mA +85°C
Note 1: Base Idle current (I
IDLE) is measured as follows:
• CPU core is off, oscillator is configured in EC mode and external clock is active; OSC1 is driven with
external square wave from rail-to-rail (EC clock overshoot/undershoot < 250 mV required)
• CLKO is configured as an I/O input pin in the Configuration Word
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD, WDT and FSCM are disabled
• No peripheral modules are operating; however, every peripheral is being clocked (all PMDx bits are
zeroed)
• The NVMSIDL bit (NVMCON<12>) = 1 (i.e., Flash regulator is set to standby while the device is in
Idle mode)
• The VREGSF bit (RCON<11>) = 0 (i.e., Flash regulator is set to standby while the device is in Sleep
mode)
• JTAG is disabled