Datasheet

dsPIC30F6010A/6015
DS70150E-page 182 © 2011 Microchip Technology Inc.
TABLE 24-8: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.5V to 5.5V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C ≤ T
A ≤ +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (IPD)
(2)
DC60a 0.2 — μA 25°C
3.3V
Base Power-Down Current
(3)
DC60b 1.2 40 μA 85°C
DC60c 12 65 μA125°C
DC60e 0.4 — μA 25°C
5VDC60f 1.7 55 μA 85°C
DC60g 15 90 μA125°C
DC61a 9 15 μA 25°C
3.3V
Watchdog Timer Current: ΔI
WDT
(3)
DC61b 9 15 μA 85°C
DC61c 9 15 μA125°C
DC61e 18 30 μA 25°C
5VDC61f 17 30 μA 85°C
DC61g 16 30 μA125°C
DC62a 4 10 μA 25°C
3.3V
Timer1 w/32 kHz Crystal: ΔI
TI32
(3)
DC62b 5 10 μA 85°C
DC62c 4 10 μA125°C
DC62e 4 15 μA 25°C
5VDC62f 6 15 μA 85°C
DC62g 5 15 μA125°C
DC63a 29 52 μA 25°C 3.3V
BOR On: ΔI
BOR
(3)
DC63b 32 52 μA 85°C
DC63c 33 52 μA125°C
DC63e 34 60 μA 25°C
5VDC63f 39 60 μA 85°C
DC63g 38 60 μA125°C
Note 1: Data in the “Typical” column is at 5V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
PD is measured with all peripherals and clocks shut down. All I/Os are configured as inputs and
pulled high. BOR, WDT, etc. are all switched off.
3: The Δ current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.