Datasheet

dsPIC30F5011/5013
DS70116J-page 168 © 2011 Microchip Technology Inc.
TABLE 23-7: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.5V to 5.5V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C ≤ TA ≤ +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Power Down Current (I
PD)
(2)
DC60a 5 25 μA 25°C
3.3V
Base Power Down Current
(3)
DC60b 8 40 μA 85°C
DC60c 14 70 μA125°C
DC60e 8 40 μA 25°C
5VDC60f 12 55 μA 85°C
DC60g 20 100 μA125°C
DC61a 7.8 12 μA 25°C
3.3V
Watchdog Timer Current: ΔI
WDT
(3)
DC61b 7.9 12 μA 85°C
DC61c 8.4 13 μA125°C
DC61e 15.4 23.1 μA 25°C
5VDC61f 14.7 22 μA 85°C
DC61g 14.1 21.1 μA125°C
DC62a 3.8 6 μA 25°C
3.3V
Timer 1 w/32 kHz Crystal: ΔI
TI32
(3)
DC62b — — μA 85°C
DC62c — — μA125°C
DC62e 5.5 10 μA 25°C
5VDC62f — — μA 85°C
DC62g — — μA125°C
DC63a 31.5 47.2 μA 25°C
3.3V
BOR On: ΔI
BOR
(3)
DC63b 34.4 51.5 μA 85°C
DC63c 36.5 55 μA125°C
DC63e 36.5 54.7 μA 25°C
5VDC63f 39.1 58.7 μA 85°C
DC63g 40.5 61 μA125°C
DC66a 19.6 29.4 μA 25°C
3.3V
Low-Voltage Detect: ΔI
LVD
(3)
DC66b 21.5 32.3 μA 85°C
DC66c 23 34.5 μA125°C
DC66e 24 36 μA 25°C
5VDC66f 25.5 38.3 μA 85°C
DC66g 26.2 39 μA125°C
Note 1: Data in the Typical column is at 5V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
PD is measured with all peripherals and clocks shut down. All I/Os are configured as inputs and
pulled high. LVD, BOR, WDT, etc. are all switched off.
3: The Δ current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.