Datasheet

© 2011 Microchip Technology Inc. DS70116J-page 209
dsPIC30F5011/5013
APPENDIX A: REVISION HISTORY
Revision F (May 2006)
Previous versions of this data sheet contained
Advance or Preliminary Information. They were distrib-
uted with incomplete characterization data.
Revision F of this document reflects the following
updates:
• Supported I
2
C Slave Addresses
(see Table 15-1)
• ADC Conversion Clock selection to allow 200 kHz
sampling rate (see Section 19.0 “12-bit Analog-
to-Digital Converter (ADC) Module”
• Operating Current (Idd) Specifications
(see Table 23-5)
• BOR voltage limits
(see Table 23-11)
• I/O pin Input Specifications
(see Table 23-8)
• Watchdog Timer time-out limits
(see Table 23-21)
Revision G (January 2007)
This revision includes updates to the packaging
diagrams.
Revision H (March 2008)
This revision includes the following updates:
• Added FUSE Configuration Register (FICD)
details (see Section 20.7 “Device Configuration
Registers” and Table 20-8)
• Updated FGS Configuration register details (see
Table 20-8)
• Removed erroneous statement regarding genera-
tion of CAN receive errors (see Section 17.4.5
“Receive Errors”)
• Electrical Specifications:
- Resolved TBD values for parameters DO10,
DO16, DO20, and DO26 (see Ta ble 2 3 -9)
- 10-bit High-Speed ADC t
PDU timing parame-
ter (time to stabilize) has been updated from
20 µs typical to 20 µs maximum (see
Table 23-39)
- Parameter OS65 (Internal RC Accuracy) has
been expanded to reflect multiple Min and
Max values for different temperatures (see
Table 23-19)
- Parameter DC12 (RAM Data Retention Volt-
age) has been updated to include a Min value
(see Table 23-4)
- Parameter D134 (Erase/Write Cycle Time)
has been updated to include Min and Max
values and the Typ value has been removed
(see Table 23-12)
- Removed parameters OS62 (Internal FRC
Jitter) and OS64 (Internal FRC Drift) and
Note 2 from AC Characteristics (see
Table 23-18)
- Parameter OS63 (Internal FRC Accuracy)
has been expanded to reflect multiple Min
and Max values for different temperatures
(see Table 23-18)
- Updated Min and Max values and Conditions
for parameter SY11 and updated Min, Typ,
and Max values and Conditions for parame-
ter SY20 (see Table 23-21)
• Additional minor corrections throughout the
document