Datasheet

dsPIC30F2011/2012/3012/3013
DS70139G-page 154 © 2010 Microchip Technology Inc.
TABLE 20-7: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.5V to 5.5V
(unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for Industrial
-40°C ≤ TA ≤ +125°C for Extended
Parameter
No.
Typical
(1)
Max Units Conditions
Power-Down Current (I
PD)
(2)
DC60a 0.3 — μA 25°C
3.3V
Base Power-Down Current
(3)
DC60b 1.3 30.0 μA 85°C
DC60c 16.0 60.0 μA125°C
DC60e 0.5 — μA 25°C
5VDC60f 3.7 45.0 μA 85°C
DC60g 25.0 90.0 μA125°C
DC61a 6.0 9.0 μA 25°C
3.3V
Watchdog Timer Current: ΔI
WDT
(3)
DC61b 6.0 9.0 μA 85°C
DC61c 6.0 9.0 μA125°C
DC61e 13.0 20.0 μA 25°C
5VDC61f 12.0 20.0 μA 85°C
DC61g 12.0 20.0 μA125°C
DC62a 4.0 10.0 μA 25°C
3.3V
Timer1 w/32 kHz Crystal: ΔI
TI32
(3)
DC62b 5.0 10.0 μA 85°C
DC62c 4.0 10.0 μA125°C
DC62e 4.0 15.0 μA 25°C
5VDC62f 6.0 15.0 μA 85°C
DC62g 5.0 15.0 μA125°C
DC63a 33.0 53.0 μA 25°C
3.3V
BOR On: ΔI
BOR
(3)
DC63b 35.0 53.0 μA 85°C
DC63c 19.0 53.0 μA125°C
DC63e 38.0 62.0 μA 25°C
5VDC63f 41.0 62.0 μA 85°C
DC63g 41.0 62.0 μA125°C
DC66a 21.0 40.0 μA 25°C
3.3V
Low-Voltage Detect: ΔI
LVD
(3)
DC66b 26.0 40.0 μA 85°C
DC66c 27.0 40.0 μA125°C
DC66e 25.0 44.0 μA 25°C
5VDC66f 27.0 44.0 μA 85°C
DC66g 29.0 44.0 μA125°C
Note 1: Data in the Typical column is at 5V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base I
PD is measured with all peripherals and clocks shut down. All I/Os are configured as inputs and
pulled high. LVD, BOR, WDT, etc. are all switched off.
3: The Δ current is the additional current consumed when the module is enabled. This current should be
added to the base I
PD current.