Datasheet

dsPIC30F2010
DS70118J-page 38 © 2011 Microchip Technology Inc.
5.1 Interrupt Priority
The user-assignable Interrupt Priority (IP<2:0>) bits for
each individual interrupt source are located in the Least
Significant 3 bits of each nibble, within the IPCx regis-
ter(s). Bit 3 of each nibble is not used and is read as a
‘0’. These bits define the priority level assigned to a
particular interrupt by the user.
Since more than one interrupt request source may be
assigned to a specific user-assigned priority level, a
means is provided to assign priority within a given level.
This method is called “Natural Order Priority” and is
final.
Natural Order Priority is determined by the position of
an interrupt in the vector table, and only affects
interrupt operation when multiple interrupts with the
same user-assigned priority become pending at the
same time.
Table 5-1 lists the interrupt numbers and interrupt
sources for the dsPIC DSC devices and their
associated vector numbers.
The ability for the user to assign every interrupt to one
of seven priority levels means that the user can assign
a very high overall priority level to an interrupt with a
low natural order priority. For example, the PLVD (Low-
Voltage Detect) can be given a priority of 7. The INT0
(external interrupt 0) may be assigned to priority
level 1, thus giving it a very low effective priority.
TABLE 5-1: dsPIC30F2010 INTERRUPT
VECTOR TABLE
Note: The user-assigned priority levels are from
0, as the lowest priority, to level 7, as the
highest priority.
Note 1: The natural order priority scheme has 0
as the highest priority and 53 as the
lowest priority.
2: The natural order priority number is the
same as the INT number.
INT
Number
Vector
Number
Interrupt Source
Highest Natural Order Priority
0 8 INT0 – External Interrupt 0
1 9 IC1 – Input Capture 1
2 10 OC1 – Output Compare 1
3 11 T1 – Timer1
4 12 IC2 – Input Capture 2
5 13 OC2 – Output Compare 2
6 14 T2 – Timer2
7 15 T3 – Timer3
8 16 SPI1
9 17 U1RX – UART1 Receiver
10 18 U1TX – UART1 Transmitter
11 19 ADC – ADC Convert Done
12 20 NVM – NVM Write Complete
13 21 SI2C – I
2
C™ Slave Interrupt
14 22 MI2C – I
2
C Master Interrupt
15 23 Input Change Interrupt
16 24 INT1 – External Interrupt 1
17 25 IC7 – Input Capture 7
18 26 IC8 – Input Capture 8
19 27 Reserved
20 28 Reserved
21 29 Reserved
22 30 Reserved
23 31 INT2 - External Interrupt 2
24 32 Reserved
25 33 Reserved
26 34 Reserved
27 35 Reserved
28 36 Reserved
29 37 Reserved
30 38 Reserved
31 39 Reserved
32 40 Reserved
33 41 Reserved
34 42 Reserved
35 43 Reserved
36 44 INT3 – External Interrupt 3
37 45 Reserved
38 46 Reserved
39 47 PWM – PWM Period Match
40 48 QEI – QEI Interrupt
41 49 Reserved
42 50 Reserved
43 51 FLTA
– PWM Fault A
44 52 Reserved
45-53 53-61 Reserved
Lowest Natural Order Priority