User manual

Using the dsPIC30F4011

11.4 DEVICE PROGRAMMING

Load the sample application program for the dsPIC30F4011 using this process:

1. Plug the RJ11 cable from the MPLAB ICD 2 into the ICD header (J1). Make sure

the USB cable from the MPLAB ICD 2 is connected to your PC.

2. Start MPLAB IDE.

3. Open the dsPIC30F4011 sample project (

File>Open Workspace

) from

path\dsPICDEM2 Development Kit\Example Soft-

ware\30F4011\Demo.mcw

4. Build the sample project in MPLAB IDE (

Project>Build All)

5. Program the dsPIC30F4011 (

Programmer>Program

). The Output window

(Figure 11-2) displays the status as the download occurs and indicates when the

programming has succeeded.

FIGURE 11-2: PROGRAMMING THE dsPIC30F4011 DEVICE

6. Disconnect the MPLAB ICD 2 cable from the ICD header. The program is now

ready to run (see Section 11.5 “Observing the Sample Application”).

Note: For detailed information and procedures on using the MPLAB IDE and ICD

2 refer to Chapter 2 “Getting Started”.