User manual

Using the dsPIC30F3014

10.4 DEVICE PROGRAMMING

Load the sample application program for the dsPIC30F3014 using this process:

1. Plug the RJ11 (telephone) cable from the MPLAB ICD 2 into the ICD header (J1).

Make sure the USB cable from the MPLAB ICD 2 is connected to your PC.

2. Start MPLAB IDE.

3. Open the dsPIC30F3014 sample project (

File>Open Workspace

)

from

path/dsPICDEM 2 Development Kit/Example Soft-

ware/30F3014/Demo.mcw

4. Build the sample project in MPLAB IDE (

Project>Build All)

5. On the dsPICDEM™ 2 board set all positions on switches S3 and S4 to off. Then

set switch S2 to GP 40. The MPLAB ICD 2 is now connected to the PGC and

PGD pins on the dsPIC30F3014.

6. Download the sample application (

Programmer>Program

). The Output window

(Figure 10-2) displays the status as the download occurs and indicates when the

programming has succeeded.

FIGURE 10-2: PROGRAMMING THE dsPIC30F3014 DEVICE

7. Disconnect the MPLAB ICD 2 cable from the ICD header. The program is now

ready to run (see Section 10.5 “Observing the Sample Application”).

Note: For detailed information and procedures on using the MPLAB IDE and ICD

2, refer to Chapter 2 “Getting Started”.