User manual

dsPICDEM 2 Development Board User’s Guide

2. Remove any dsPIC30Fxxxx device currently plugged into the dsPICDEM 2

Development Board.

3. Plug the dsPIC30F3014 into socket U1A1.

4. Configure the hardware components as shown in Table 10-1.

5. Connect the RS-232 cable from the PC to the UART connector (J2).

6. Reapply power to the DC IN connector (J4). The PWR ON LED should illuminate.

7. Load the sample application program for the dsPIC30F3014 (see

Section 10.4 “Device Programming”).

TABLE 10-1: HARDWARE CONFIGURATION SETTINGS

Component

Header Socket U1A1

No.

Jumper

Setting

Pin Device Functions (see Figure 10-1)

Jumper JP1 JP1 Jumper — 5 VDC jumper installed

Jumper JP2 JP2 Jumper — 5 VDC jumper installed

Selector Switch S2 GP 40 ON 8-9 PGC and PGD

Selector Switch S3 OFF — Not used in this configuration

Selector Switch S4 OFF — Not used in this configuration

PGM U3 H11 Open — —

CAN Tx H2 Open — —

CAN Rx H2 Open — —

UART1 Tx* H3 Open — —

UART1 Rx* H3 Open — —

Alternate UART1 Tx

* H4 GP ALL 15 EMUD1/SOSCI/T2CK/U1ATX/CN1/RC13

Alternate UART1 Rx

* H4 GP ALL 16 EMUC1/SOSCO/T1CK/U1ARX/CN0/RC14

UART2 Tx* H5 Open — —

UART2 Rx* H5 Open — —

Temperature Sensor H10 GP ALL 5 AN3/CN5/RB3

Potentiometer H13 GP ALL 4 AN2/SS1

/LVDIN/CN4/RB2

Switch S5 H6 GP 40/28 17 INT0/RA11

Switch S6 H7 GP 40 23 IC1/INT1/RD8

LED D3 H12 GP D3 2 AN0/V

REF+/CN2/RB0

LED D4 H12 GP D4 3 AN1/V

REF-/CN3/RB1

LCD - SPI™ Clock* H1 GP 40/28 24 EMUC3/SCK1/RF6

LCD - SPI Data* H1 GP 40/28 25 EMUC3/U1TX/SDO1/SCL/RF3

* Since only one DB-9 connector is provided for RS-232 communication, you can

select either UART1 (primary or alternate pins) or UART2, but not both.