User manual

dsPICDEM 2 Development Board User’s Guide

3. Plug the dsPIC30F3010 into socket U2B1.

4. Configure the hardware components as shown in Table 6-1.

5. Connect the RS-232 cable from the PC to the UART connector (J2).

6. Reapply power to the DC IN connector (J4). The PWR ON LED should illuminate.

7. Load the sample application program for the dsPIC30F3010 (see

Section 6.4 “Device Programming”).

TABLE 6-1: dsPIC30F3010 CONFIGURATION SETTINGS

Component

Header Socket U2B1

No.

Jumper

Setting

Pin Device Functions (see Figure 6-1)

Jumper JP1 JP1 Jumper — 5 VDC jumper installed

Jumper JP2 JP2 Jumper — 5 VDC jumper installed

Selector Switch* S2 M ALL ON 17,18 PGC and PGD

Selector Switch* S3 OFF — Not used in this configuration

Selector Switch* S4 OFF — Not used in this configuration

PGM U3 H11 Open — —

CAN Tx H2 Open — —

CAN Rx H2 Open — —

UART1 Tx* H3 Open — —

UART1 Rx* H3 Open — —

Alternate UART1 Tx

* H4 M ALL 11 EMUD1/SOSC1/T2CK/U1ATX/CN1/RC13

Alternate UART1 Rx

H4 M ALL 12 EMUC1/SOSCO/T1CK/U1ARX/CN0/RC14

UART2 Tx* H5 Open — —

UART2 Rx* H5 Open — —

Temperature Sensor H10 M ALL 5 AN3/INDX/CN5/RB3

Potentiometer H13 M ALL 4 AN2/SSI

/CN4/RB2

Switch S5 H6 Open — —

Switch S6 H7 M ALL 15 EMUC2/OC1/IC1/INT1/RD0

LED D3 H12 M D3 2 EMUD3/AN0/V

REF+/CN2/RB0

LED D4 H12 M D4 3 EMUC3/AN1/V

REF-/CN3/RB1

LCD - SPI™ Clock* H1 M 28 16 FLTA/INT0/SCK1/OCFA/RE8

LCD - SPI Data* H1 M 28 17 PGD/EMUD/U1TX/SDO1/SCL/RF3

* On this device, multiplexing of various peripherals on the pins does not allow the

simultaneous use of:

– Switch S5 and LCD

– Primary UART1 pins and LCD.

Since only one DB-9 connector is provided for RS-232 communication, you can

select either UART1 (primary or alternate pins) or UART2, but not both.