User manual

dsPICDEM 2 Development Board User’s Guide

3.5 OBSERVING THE SAMPLE APPLICATION

1. Press RESET ALL. The program begins to run.

2. Set up a HyperTerminal session on the PC to run with these parameters:

As a shortcut, you can launch the Hyperterminal_RS232_dsPICDEM2.ht

file in the dsPICDEM 2 Development Kit/Example Software/30F2010

folder.

3. See information on LCD. Note that the HyperTerminal displays the same

information.

4. Adjust temperature and note LCD and HyperTerminal readings.

5. Adjust potentiometer and note LCD and HyperTerminal readings.

6. Observe the rate at which LEDs D3 and D4 blink.

7. Press S6 (INT1) and note the affect on D3 and D4.

Port Setting Value

Bits per second 9600

Data bits 8

Parity None

Stop bits 1

Flow control None