Datasheet

 2012 Microchip Technology Inc. DS30575A-page 337
PIC18F97J94 FAMILY
18.4.8 OPERATION IN POWER-MANAGED
MODES
In Sleep mode, all clock sources are disabled.
Timer2/4/6/8 will not increment and the state of the
module will not change. If the ECCPx pin is driving a
value, it will continue to drive that value. When the
device wakes up, it will continue from this state. If
Two-Speed Start-ups are enabled, the initial start-up
frequency from HF-INTOSC and the postscaler may
not be stable immediately.
In PRI_IDLE mode, the primary clock will continue to
clock the ECCPx module without change.
18.4.8.1 Operation with Fail-Safe
Clock Monitor (FSCM)
If the Fail-Safe Clock Monitor (FSCM) is enabled, a clock
failure will force the device into the power-managed
RC_RUN mode and the OSCFIF bit of the PIR2 register
will be set. The ECCPx will then be clocked from the
internal oscillator clock source, which may have a
different clock frequency than the primary clock.
18.4.9 EFFECTS OF A RESET
Both Power-on Reset and subsequent Resets will force
all ports to Input mode and the ECCP registers to their
Reset states.
This forces the ECCP module to reset to a state
compatible with previous, non-enhanced CCP modules
used on other PIC18 and PIC16 devices.