User manual

Getting Started
 2015 Microchip Technology Inc. DS40001804A-page 13
Select options category “Program Options” and then “Enable Low Voltage
Programming,” if it is not already selected. Click Apply, then OK (Figure 2-3). Once the
project is finished, the microcontroller is ready to be programmed. Simply click on the
Make and Program Device Main Project button and the device will be programmed
(Figure 2-4).
FIGURE 2-4: PROGRAMMING THE DEVICE ON THE CURIOSITY DEVELOPMENT BOARD
Note: When using the PKOB for programming, the Low Voltage Programming
(LVP) bit of the Configuration Word(s) must be set (LVP = ON or '1').