User manual

F1 LV EVALUATION PLATFORM
USER’S GUIDE
 2011 Microchip Technology Inc. DS41614A-page 21
Chapter 3. Programming the F1 LV Evaluation Platform
3.1 INTRODUCTION
The F1 LV Evaluation Platform makes extensive use of the on-board peripherals of the
PIC16LF1947. This chapter provides guidance concerning the tools used for
programming the F1 LV Evaluation Board and a map of the board function to I/O pin
and pin function.
3.2 PROGRAMMING/DEVELOPMENT TOOL SUPPORT
The following development tools support the F1 LV Evaluation Platform:
1. PICkit™ 3
2. ICD 3
3. REAL ICE™ in-circuit emulator (with adapter AC164110)
The PICkit™ or ICD 3 tools can also power the F1 LV Evaluation Platform, therefore,
no additional hardware is required to get started. The ICSP pins of the PIC16LF1947
are dedicated to the PICkit ICSP connector, eliminating interactions between the
Evaluation Platform and the programmer/debugger.
If you are developing with the REAL ICE emulator ICD, you will need the AC164110
adaptor, or the high-speed trace adaptor. These adaptors provide the inline 6-pin
connector required by the PICkit ICSP programming capability interface. You will also
need a power supply, please see Chapter 2. “Getting Started” for more on powering
the F1 LV Evaluation Platform.