Datasheet

F1 Evaluation Platform User’s Guide
DS41401B-page 14  2010 Microchip Technology Inc.
3. Configure the PICkit 3 to supply a voltage between 1.8 and 3.6V. For proper LCD
contrast, the supply should be 3.3V.
4. Attach the PICkit 3 to the PICkit ICSP™ connector at the end of the board.
5. Activate the PICkit 3 power output.
2.4 POWERING WITH THE CONNECTOR AT JP3
To power with the connector at JP3, perform the following steps:
1. Make sure a jumper or an ammeter is connected across JP2.
2. If you are using a BLDC expansion, remove the jumper at JP1.
3. Verify the supply voltage to be between 1.8 and 3.6V. For proper LCD contrast,
the supply should be 3.3V.
4. Attach the power supply to JP3.
5. Turn on the power supply.
FIGURE 2-2: POWERING WITH THE CONNECTOR AT JP3
2.5 POWERING WITH PICkit™ SERIAL
To power with the PICkit Serial, perform the following steps:
1. Make sure a jumper or an ammeter is connected across JP2.
2. If you are using a BLDC expansion, remove the jumper at JP1.
3. Configure the PICkit Serial to supply a voltage between 1.8 and 3.6V. For proper
LCD contrast, the supply should be 3.3V.
4. Attach the PICkit Serial to the PICkit Serial connector at the top corner of the
board.
5. Activate the PICkit Serial power output.