User manual

PICDEM.net™ 2 Development Board User’s Guide
DS51623D-page 22  2011 Microchip Technology Inc.
TABLE 3-1: JUMPER DESCRIPTIONS
FIGURE 3-1: JUMPER LOCATIONS ON THE DEVELOPMENT BOARD
Number
Board
ID(s)
Type Description
1 JP1 Bridge U1 (temperature sensor) to RA3
2 JP2 Bridge J2 Power (ENC28J60 Ethernet jack)
3 JP3 Bridge J1 Power (PIC18F97J60 Ethernet jack)
4 JP4 Bridge LED Bank (D1 through D8)
5 JP5 2-Way Select ENC28J60 Reset Control (RD2) or Device Disable
6 JP6 Bridge J1 Ethernet Activity LED Enable (LEDA)
7 JP7 Bridge RA0/LEDA to PICtail™ Daughter Board Header
8 JP8 Bridge J1 Ethernet Link LED Enable (LEDB)
9 JP9 Bridge ENC28J60 INT
to RB0 (normally open)
10 JP10 Bridge RA1/LEDB to PICtail Daughter Board Header (LEDB)
11 JP11 Bridge ENC28J60 Power
12 JP12 Bridge U4 (EEPROM) SPI Chip Select to RD7
13 JP13 Bridge USART Transmit (microcontroller perspective)
14 JP14 Bridge USART Receive (microcontroller perspective)
15 JP15 Bridge PIC18F97J60 Power
16 JP16 Bridge R38 (potentiometer) to RA2
17 JP17, JP22 Bridge Y3 (Timer1 oscillator)
18 JP18 Bridge S2 (RB0 user-defined push button)
19 JP19 Bridge S3 (RB1 user-defined push button)
20 JP20 Bridge S4 (RB2 user-defined push button)
21 JP21 Bridge S5 (RB3 user-defined push button)
22 JP23 Bridge ENC28J60 SPI Chip Select to RD3
4
18 19
1 2
3 5
6
15
8
9
10
16
17
13
12
14
11
7
22
20 21
PICDEM.net™ 2
Development
Board
PICtail™
Daughter
Board