User's Manual
Table Of Contents
- Operating Conditions
- Features
- WLAN
- Bluetooth (Optional)
- Memory Interfaces
- Communication Interfaces
- Audio and Graphics Interface
- Input/Output
- Applications
- Table of Contents
- Most Current Data Sheet
- Errata
- Customer Notification System
- 1.0 System Overview
- 2.0 CY920 Board Layout and Features
- 3.0 Application Guidelines
- 4.0 Wi-Fi Specification
- 5.0 Bluetooth Specifications
- 6.0 Packaging Information
- 7.0 Electrical Characteristics
- 8.0 Regulatory Compliance and Quality
- 9.0 Ordering Guide
- Appendix A: Certification Notices
- Federal Communications Commission Interference Statement
- Labeling Requirements
- RF Exposure Warning
- Information for the OEMs or Integrators
- Information to be Supplied to the End User by the OEM or Integrator
- Japan
- Canada, Industry Canada (IC) Notices
- RF Exposure Information
- Canada, avis d'Industry Canada (IC)
- Informations concernant l'exposition aux fréquences radio (RF)
- Appendix B: Revision History
- The Microchip Web Site
- Customer Change Notification Service
- Customer Support
© 2014 Microchip Technology Inc. Preliminary DS60001270C-page 9
CY920
Table 1-4 provides the GPIO assignment on the CY920
module.
TABLE 1-4: CY920 GPIO MAPPING
1.1.2 ANTENNA CONNECTOR
In the CY920 module two external antenna sockets are
used to enable diversity operation. During the diversity
operation, the firmware selects one antenna at a time
through the on-board Tx/Rx diversity RF switch.
The surface-mounted antenna socket used in the
CY920 module is Ultra Small Surface Mount Coaxial
(U.FL) type.
GPIO
Number
DM920 Pin Name Connected To Assigned Function
0 MIICRS BT/extended connector WLAN_ACTIVE
1 MIICOL BT/extended connector BT_PRIORITY
2 MIITXER BT/extended connector BT_ACTIVE
3 MIITXCLK BT/extended connector BT_LDO_ON
4 AV3CLK Basic connector Available
5 AV3CTRL0 Basic connector Available
6 AV3CTRL1 Basic connector Chip select for expansion Flash
7 AV0CTRL2 Extended connector Available
8 MIITXD2 Basic connector Factory Reset
9 MIITXD3 Basic connector IR input
10 MIIRXD2 Basic connector SPI_REQ for Host controller
11 MIIRXD3 Basic connector Available
12 HDDATA12 Extended connector Available
13 HDDATA13 Extended connector Available
14 HDDATA14 Extended connector Available
15 HDDATA15 Extended connector Available
16 SPF0 Basic connector HD_INT
17 SPF1 Basic connector Ethernet Reset
18 EXT_PA_EN1_5 Basic connector FEM BSEL
19 EXT_PA_EN1_24 Basic connector Available
Note 1: The GPIO assignments are subject to change in future revisions of this document.
Note: Do not use the CY920 module that has
two external antenna sockets with only
one external antenna connected. This will
degrade the Wi-Fi or BT performance.